Top View of Shelf Support Inspection Area – Bottom of shelf bracket

RE:

Safety Alert: Randell Prep Table-Model 8395NLCPR Mullion Shelf Support Bracket

On March 5th, 2013 Unified Brands was notified that a Randell Prep Table located at a Little Caesers location, SNW204418-1-1 (Manufactured June 2012), was found to have a shelf support bracket with sharp edges located on the 90° downward bend of the Mullion Shelf Support Bracket (TPT_2LH_1) as indicated in the picture below.

Top View of Shelf Support

Inspection Area – Bottom of shelf bracket

Upon immediate investigation, we have determined that this unit in question was manufactured during the time frame when Unified Brands changed to an automated manufacturing process which may have led to inconsistent final inspection/detection for sharp edges. Upon your request on April 1st 2013, we physically inspected 42 units in your warehouse and found 2 units that had the potential of causing injury. In addition to these 2 units we also identified 8 others that had small rounded burrs but posed zero hazards. The 2 units identified as hazards were repaired and the other 8 had additional finishing to the part in question. CORPORATE OFFICE: 1055 Mendell Davis Drive, Jackson, MS 39272 ADDITIONAL LOCATIONS: PRYOR OK • WEIDMAN MI • KANSAS CITY MO 888.994.7636 • FAX 888.864.7636 • unifiedbrands.net UNIFIED BRANDS IS AN ISO 9001 REGISTERED COMPANY © 2013 Unified Brands. All Rights Reserved. Unified Brands is a wholly-owned subsidiary of Dover Corporation.

We have since isolated and adjusted our manufacturing and inspection processes to prevent such occurrences from happening in the future. Based on the analysis and findings of the warehouse inspection, we believe that there may be a 2% population risk on units shipped starting from April 15th, 2012. Attached is a list of Serial Numbers that fall within the date range in question which accounts for 445 units. The Spreadsheet also identifies the 43 serial numbers where a physical inspection has already been made. Based on our findings, we believe that a field campaign is not necessary at this time, however In an effort to proactively address this with the stores, we recommend that a communication is sent to all store locations to inspect the Brackets for any sharp edges (note – there may be natural burrs that will pose no danger and will not need correction). If any store identifies a significant hazard, we will dispatch a local Authorized Service Agent to remove the sharp edges. This process of removing the sharp edge will only take 5-10 minutes. I want to thank you for allowing us the opportunity to address this concern. Our primary concern is for the Safety of our end users. Please contact myself or Scott Sandel for additional questions on this or any other matter. Sincerely,

Vice President – Quality / Continuous Improvement UNIFIED BRANDS

Customer service 888-994-7636