This Nissan lift with the K21 engine is showing code e27 on panel. I replaced the crank sensor but engine is still running rough with a lack of power. No change in how it runs between the old crank sensor and the new one. I have also replaced the cam sensor.
Re: code e-27 error code
hiandlotech
by hiandlotech » Tue Dec 06, 2016 9:10 pm
Posts: 64 Joined: Fri Aug 26, 2016 8:38 pm
Hello!! And welcome to fixaforklift.com E-27 is defined as a crank sensor code, Since you have replaced the crank sensor we can rule that out, if you have not already done so make sure all ignition connections are where they are supposed to be. It is an ignition related code, it is possible that something as simple as the spark plug gap being too worn out or even bad spark plugs, best best is to start with a basic tune up. See Error Code Chart Replace spark plugs and make sure the GAP is correct, which is 0.38 (.096mm) if the gap is wider it could trigger that code, the code may still be present so to refresh the dash disconnecting the battery may not always reset it you would have to do the manual pedal reset which goes as follows. Just remember 3-5-7 Turn the ignition switch on with accel. pedal released,after 3 seconds fully depress the accel pedal 5 times within 5 seconds(end in released position). After 7 seconds(timing is very important...1 mississippi 2 mississippi etc....) press and hold down accel pedal for approximately 10 seconds(again timing) until the hour meter starts blinking, release pedal and push down and hold again for 10 seconds) hour meter should be on with no codes showing,shut key off and test to see if codes cleared.
Caterpillar Certified- Nissan Certified Clark Technician- Jungheinrich mexiCAN
Post Reply
2 posts • Page 1 of 1
Similar Topics
Error code by Murray » Thu Jan 11, 2018 3:18 pm » in Nissan Electric Forklifts
Nissan electric error code 446* by Marc » Tue Jan 23, 2018 10:52 am » in Nissan Electric Forklifts
Caterpillar ep25k pac error 12 by Antonio » Fri Sep 15, 2017 2:42 am » in Caterpillar Electric Forklifts
Replies
Views
Last post
2
119
by Murray Mon Jan 15, 2018 2:43 pm
3
104
by Marc Tue Jan 23, 2018 1:07 pm
1
200
by hiandlotech Tue Sep 19, 2017 8:12 am
Return to “Nissan LP Gas Forklifts”
Board index
Contact us
Delete all board cookies
code e-27 error code - FixaForklift.com
Search…
Quick links
FAQ
Image Gallery
Register
Login
Board index ‹ Nissan ‹ Nissan LP Gas Forklifts
code e-27 error code 2 posts • Page 1 of 1
...
